Legend-audio ATP 7500 User Manual download pdf (Page 14)

Page 14

Remote Control Programming

The remote allows you to transfer a command from a button

on your source remote control (original equipment remote

control) to a button on the ATP7500 remote control. In the

CD, DVD, AUX, SAT, TV,VCR and CBL device modes, new

commands can be taught to any button except the LIGHT button.

The remote control provides distinct visual feedback with

LEDs (Light Emitting Diodes) that are located at the top left of

the remote control (Status LED) and under the Device buttons.

The Status LED at the top left of the remote operates in three

colors (red, orange and green). The Device buttons have a

red color LED behind them. These LEDs will assist you in

programming in the learning section of the remote control.

Learning a New Command

Select a Device mode in which you would like to teach the

new command. For example, if you wanted to learn a new

command to the PREV CH button in the TV mode on the

remote, you would select the TV Device button and then use

the instructions below to teach the new command to the

PREV CH button.

Step 1. Press the Device button and the SELECT button

simultaneously, and hold until the orange Status LED

and the Device button turn on and remain lit.

Step 2. On the remote control, press the button that is to be

taught the new command. The orange Status LED will

begin to flash continuously. The Device LED will turn off.

Step 3. On the source remote control (the original remote

control), press and hold the button for the command

to be learned until the Status LED on the remote

turns green. Release the button on the source remote.

Step 4. Press the button on the source remote control, once

again to verify that the new command has been

learned correctly. The Status LED will flash green

twice and then turn to a steady orange color

indicating that the programming was successful.

The Device LED will turn on.

Repeat Steps 2 through 4 for any other buttons to be taught

in the Device mode selected in Step 1.

Step 5. Once you have completed learning new commands

to the buttons in the selected Device mode, you must

save the programmed information. Press and hold

the Device button and SELECT button simultaneously,

and hold until the orange Status LED flashes twice.

The Device button will turn off.

Please repeat for any other Device modes starting from Step 1.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Legend-audio ATP 7500 User Manual Page 14

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Legend-audio ATP 7500